The tool goes in the "MANUALE (0X00EE)" status when the system can't automatically identify the ECU. This happens when the identification numbers are not present in the Dimsport databank.
Follow the instructions here below on how to proceed.
1. Check the status of your My Genius unit to confirm.
2. Download the ID file from My Genius and send it to your Master via email.
8. Lastly, upload the .FPF file and write it into the ECU.
3. The Master will notify you when the setting file is available in the databank.
ATTENTION: after the confirmation from your Master, you MUST wait AT LEAST 30 minutes before moving to next steps.
4. Reset the device.
ATTENTION: after the confirmation from your Master, you MUST wait AT LEAST 30 minutes before moving to next steps.
4. Reset the device.
5. Perform a full update.
6. Perform again the identification (ID) of the vehicle.
N.B. Now the identification will be automatically carried out.
If it's still performed manually, you have to contact your Master.
7. Download the ID file, send it to your Master via email (see step number 2) and wait for the modified file (_MOD.FPF) from the Master.
N.B. Now the identification will be automatically carried out.
If it's still performed manually, you have to contact your Master.
7. Download the ID file, send it to your Master via email (see step number 2) and wait for the modified file (_MOD.FPF) from the Master.
8. Lastly, upload the .FPF file and write it into the ECU.